Ohaus NAVIGATOR NVT Ethernet Interface Manual multi - Manual (Page 5)

Ethernet Interface EN-3
Output examples: (Note: * and _ indicate spaces, CR/LF not shown)
*****192.21_g - Manual, Continuous or On-Stable printing
*******0.01_g_? unstable reading
*******0.01_g___00:00:00
- Interval Printing (example:15sec interval)
*****176.30_g_?_00:00:15 unstable reading
*****192.08_g___00:00:30
*****192.21_g
*****207.80_g_TOTAL - Accumulate Mode (Manual printing only)
Input
The scale will respond to various commands sent via the interface. The commands must be
terminated with a [CR] or [CRLF].
0P Turns Auto-Print off
SLP Auto-Print on, prints on stability (non-zero value only)
SLZP Auto-Print on, prints on stability (zero and non-zero values)
CP Continuous Auto-Print
(x)P Auto-Print on 1 to 3600 second intervals (x = 1 to 3600)
PM Sends current mode
M Advance to next enabled mode
PU Sends current unit
U Advance to next enabled unit
T Tares balance, same as pressing TARE
Z Zeros balance, same as pressing ZERO
PV Sends software version
P Same as pressing PRINT
IP Immediately sends stable or unstable value
SP Sends stable data only
Auto-Print Operation
Once Auto-Print is activated in the menu, the balance will send data as required. To temporarily stop
Auto-Printing, press the PRINT key. If there is data in the print buffer the printer will finish printing this
data. A second press will resume Auto-Printing.
(Note: In some modes, stopping or resuming Auto-Print must be done when the balance is not
reading “0”.)
ACCESSORIES
For a complete listing of Ohaus printers and other accessories, contact Ohaus Corporation or visit
www.Ohaus.com