Manhattan 525480 150N Wireless Router - Manual - Manual (Page 29)

29
SYSTEM & NETWORK SETUP
Subnet Mask — Enter the subnet mask for this network.
802.1d Spanning Tree — Select “Enable” or “Disable” from the drop-down menu.
DHCP Server — Select “Enable” or “Disable” from the drop-down menu.
2.6.2 DHCP Server
These settings are only available when “DHCP Server” in the LAN IP section is
enabled, but will also affect wireless clients.
Lease Time — Choose a lease time (the duration that every computer can keep a
specific IP address) from the drop-down menu of every IP address assigned by
this router.
Start IP — Enter the start IP address of the IP range.
End IP — Enter the end IP address of the IP range.
Domain Name— Enter a domain name for your network. (optional)
NOTE: The number of the last field (the “d” field) of “End IP” must be greater than
“Start IP” and can’t be the same as the router’s IP address. Also, the first three
fields of the IP address of “Start IP,” “End IP” and “IP Address” in the LAN IP
section (the “a,” “b” and “c” fields) should be the same.
RECOMMENDED VALUES
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0 802.1d Spanning Tree: Disabled
DHCP Server: Enabled
RECOMMENDED VALUES
Lease Time: Two Weeks (or “Forever” if
you have fewer than 20 computers)
Start IP: 192.168.2.100
End IP: 192.168.2.200
Domain Name: (leave it blank)