Philips SCD510 User Manual

Page 8

important information about non-rechargeable and rechargeable batteries

- Non-rechargeable batteries and rechargeable batteries may explode if exposed to sunshine, fire

or high temperatures due to other causes.

- Always place rechargeable batteries of the correct type in the parent unit to avoid the risk of

explosion. Do not use non-rechargeable batteries to avoid the risk of explosion.

- Always place non-recheargeable batteries of the correct type in the baby unit to avoid the risk

of explosion. The baby unit does not have a charging function.

- Make sure that your hands are dry when you insert or replace non-rechargeable batteries

or rechargeable batteries.

- To avoid damage due to leakage of non-rechargeable or rechargeable batteries:

1 Do not expose the appliance to temperatures higher than 35°C.

2 Remove the rechargeable batteries of the parent unit and the non-rechargeable batteries of the

baby unit if you are not going to use the appliance for one month or more.

3 Do not leave empty non-rechargeable batteries in the baby unit.

- Dispose of non-rechargeable batteries and rechargeable batteries properly (see chapter

‘Environment’).
electromagnetic fields (eMF)

This Philips AVENT appliance complies with all standards regarding electromagnetic fields (EMF). If

handled properly and according to the instructions in this user manual, the appliance is safe to use

based on scientific evidence available today.

Preparing for use

Baby unit

You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to

use the unit from the mains, we advise you to insert the non-rechargeable batteries. This guarantees

automatic back-up in case of mains failure.

Mains operation

Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. 2).

, The power-on light goes on.

Operation on non-rechargeable batteries

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use

Philips LR6 PowerLife batteries.

Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the

non-rechargeable batteries.

Remove the lid of the compartment for non-rechargeable batteries. (Fig. 3)

Insert four non-rechargeable batteries (Fig. 4).

Note: Make sure the + and - poles point in the right direction.

Reattach the lid. (Fig. 5)

Note: When the batteries are low, the battery light on the baby unit flashes red.

EngliSh