Philips SCD510 User Manual

Page 11

sound level lights

The parent unit continuously monitors the sound level in your baby´s room and the sound level

lights let you know if there is any activity. If your baby cries, you see the sound level lights light up on

the parent unit.

- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are out.

- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on.

The number of lights that go on is related to the loudness of the sound picked up by the

baby unit.
nightlight

Press the nightlight button Q on the baby unit to switch on the nightlight. (Fig. 23)

Press the nightlight button Q again to switch off the nightlight.

, The nightlight dims gradually before it goes out completely.
Tip: Switch off the nightlight when you operate the baby unit on the non-rechargeable batteries. This

saves power.

Paging the parent unit

If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button

on the baby unit to locate the parent unit.
Note: The paging function only works when the parent unit is switched on.

Press the PAGE button on the baby unit (Fig. 24).

, The parent unit produces a paging alert tone.

To stop the paging alert tone, press the PAGE button again or press any button on the parent

unit.
Out of range alert

When the parent unit is out of range of the baby unit, the parent unit beeps from time to time. The

LINK light on the parent unit flashes red.
Note: The LINK light on the parent unit also flashes red when the baby unit is switched off.

Microphone sensitivity

You can set the microphone sensitivity of the baby unit to the desired level with the SENSITIVITY

button on the parent unit. You can only change the microphone sensitivity when a connection

between the baby unit and the parent unit has been established, i.e. when the LINK light on the

parent unit lights up green continuously.

Briefly press the SENSITIVITY button on the parent unit (Fig. 25).

, The sound level lights light up for approx. 2 seconds to indicate the current sensitivity level.

Briefly press the volume + and - buttons on the parent unit until the desired microphone

sensitivity level for the baby unit has been reached.

, one light on = minimum sensitivity level

, all lights on = maximum sensitivity level
Note: When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and

therefore transmits more often. As a result, the units consume more power.

EngliSh