Dunlop Manufacturing 95Q - Manual (Page 2)

DUNLOP MANUFACTURING, INC.
P.O. Box 846, Benicia, CA 94510 U.S.A.
Tel: 707/745-2722 Fax: 707/745-2658
www.jimdunlop.com
92503000500
SET-UP INSTRUCTIONS
1.
Open the battery compartment door in the bottom
plate and insert a new alkaline 9 volt battery, or plug in
the approved AC adaptor. The CRYBABY 95Q will oper-
ate on either power source. You can leave the battery
in place when using AC power.
2.
Run a cord from your guitar to the CRYBABY’s Instru-
ment jack. The jacks are located on the left and right
sides of the CRYBABY’s housing. To see which jack is
which, read the top of the pedal’s rubber footpad.
3.
Run another cord from your amplifier input into the
Amplifier jack. Turn on the amplifier.
4.
To turn the pedal on and use it, simply press it in the
“toe-down” direction. The farther down you press it,
the deeper the wah effect gets.
5.
See the other side of this sheet for the operation
of the Variable Q, Volume Boost and Boost On/Off con-
trols. These controls add flexibility to your wah effects.
6.
Have fun! The CRYBABY series is built to last under
the toughest performance conditions, and will give you
many years of tone-bending pleasure.