Dunlop Manufacturing Fuzz Face User Manual
Fuzz face
Fuzz Face
Putting in Battery:
1. Remove bottom plate by turning the center screw
counterclockwise.
2. Attach battery clip to a 9 volt battery.
3. Place battery in Fuzz Face as in the diagram below.
4. Line up bottom plate so that rubber pads make contact with
battery. This keeps battery in place.
5. Holding Fuzz Face with bottom plate snug in place, feed the
screw through hole and turn clockwise until tight.
6. Remove 1/4” plug from input jack when not in use to prevent
battery from draining.
Using the Fuzz Face:
1. Connect guitar to Fuzz Face input. Connect Fuz Face output
to amplifier input.
2. Step on the switch.
3. Turn up the volume for desired effect.
92500864050
See also other documents in the category Dunlop Manufacturing Audio accessories:
- JHM1 (2 pages)
- M195 (2 pages)
- 95Q (4 pages)
- M108 (2 pages)
- DVP3 (2 pages)
- 105Q (2 pages)
- GCB80 (1 page)
- ZW38 (2 pages)
- DVP1 (2 pages)
- ZW45 (2 pages)
- M107 (2 pages)
- CSP202 (2 pages)
- M116 (2 pages)
- M133 (2 pages)
- MC404 (2 pages)
- M152 (2 pages)
- JD4S (2 pages)
- CSP026 (2 pages)
- M89 (2 pages)
- WHE203 (2 pages)
- M77 (2 pages)
- FFM2 (2 pages)
- M193 (2 pages)
- SF01 (2 pages)
- M87 (2 pages)
- M148 (2 pages)
- HT1 (2 pages)
- MC403 (2 pages)
- GCB95F (2 pages)
- KH95 (2 pages)
- JH2 (2 pages)
- CGB95 (2 pages)
- CSP028 (2 pages)
- JC95 (2 pages)
- M173 (2 pages)
- FFM1 (2 pages)
- M80 (2 pages)
- M78 (2 pages)
- M117 (2 pages)
- M82 (2 pages)
- M115 (2 pages)
- M84 (2 pages)
- UV-1 ROTATING SPEAKER EFFECT (1 page)
- M234 (2 pages)