Concord WANDERER INSTRUCTION MANUAL - Manual (Page 8)

31 30
_ FITTING AND REMOVING THE SEAT UNIT
The CONCORD WANDERER is equipped with ProFix adapters ( 15 ).
These adapters are used to attach the CONCORD WANDERER’s seat unit
(04) to the stroller frame. You can fit the seat unit in one of two directions:
either in the direction of travel or facing backwards.
To do so, insert the seat unit
from above into the ProFix
sockets (
15 ) on the stroller
frame and push until you
hear it lock into place.
WARNING!
• Always lock the safety brake before fitting or removing the seat unit.
• Always make sure you have secured the seat unit to the stroller frame
before you place your child in the seat unit.
• Every time you use the CONCORD WANDERER, first make sure that all
closures and locking mechanisms have been properly closed and locked
into place.
Tip : Your specialist retailer stocks CONCORD accessories (CONCORD AIR,
CONCORD SCOUT, CONCORD SLEEPER) that are equipped with ProFix
adapters matching the CONCORD WANDERER. This makes it simple to
attach them to the CONCORD WANDERER.
Before use, check that the CONCORD accessory is correctly locked into
place in the CONCORD WANDERER.
Please also follow the operating instructions included with the CONCORD
accessory.
WARNING!
• Never remove the seat frame from the stroller chassis if a child is still sitting
there.
To remove the seat unit ( 04 ) from the
stroller frame, press the seat unit’s
ProFix control unit (
14 ) on the left
and right at the same time and pull
this up and away from the stroller
frame.