Concord WANDERER INSTRUCTION MANUAL User Manual
Page 6
27
26
_ ATTACHING AND REMOVING THE REAR WHEELS
To attach the real wheel, press and
hold the push-button (
18
) and insert
it into the socket on the CONCORD
WANDERER, pushing it until you
hear it click into place.
To remove the real wheel, press and
hold the push-button (
18
) and pull
the wheel out of the socket on the
stroller.
_ UNFOLDING AND FOLDING UP THE STROLLER
Always make sure you check that
the closures have locked properly
into place.
Now place the seat unit (
04
) (see FITTING
AND REMOVING THE SEAT UNIT) or a
CONCORD-approved accessory into the
ProFix sockets (
15
).
To unfold the CONCORD WANDERER, lie the stroller on a flat and
clean surface with the handlebar (
02
) pointing upwards and release the
transportation lock (
12
).
Use the handlebar (
02
) to pull the CONCORD WANDERER upwards, so
that it unfolds itself. Keep pulling upwards until the stroller has unfolded
completely and you hear it lock into place.
Before folding up the CONCORD WANDERER, lock the safety brake into
place (see USING THE SAFETY BRAKE) and then remove all CONCORD
accessories (CONCORD AIR, CONCORD SLEEPER, CONCORD SCOUT or
CONCORD SNUG).
To make the stroller easier to handle and to ensure it folds up smaller,
you can remove the seat unit (
04
) before folding it up (see FITTING AND
REMOVING THE SEAT UNIT).
Press and hold the adjustment knobs (
03
) and fold
the handlebar (
02
) down as far as it will go (see
ADJUSTING THE HANDLEBAR).