Concord WANDERER INSTRUCTION MANUAL - Manual (Page 12)

39 38
_ USING THE RAIN COVER
To use the rain cover, pull the cover
down from top to bottom over the
seat frame.
Please ensure the rain cover is
completely dry before replacing the
cover in the storage bag!
_ FITTING, REMOVING AND CLEANING THE
STROLLER COVER
Note: the footrest ( 09 ) must be moved into its upright position before
removing or attaching the cover!
The individual parts of the CONCORD WANDERER’s cover are connected
together and secured to the tube frame using press studs and Velcro
fasteners. To remove the cover, first undo all of these fasteners and thread
the cover out of the Keder rail, starting with the cover near the footrest.
Before washing the cover, thread the saftey harness straps out of the plastic
eyelets and remove the harness buckle. Remove the back plate from the
closable bag on the rear of the cover.
To replace the cover, thread the cover into the Keder rail, starting with the
head area and finishing with the footrest area. Close the press studs and
then use the Velcro fasteners to connect the cover parts together.
Replace the straps from the tilt
adjustment system and thread
these as shown through the plastic
eyelet. Check to ensure that all
straps are correctly positioned and
secured.
After washing the cover, guide the straps from the harness bucklet through
the matching plastic eyelets and check to ensure the harness is working
properly and safely! Then replace the back plate in the closable bag on the
rear of the cover and press the Velcro fastener together.
• The cover material colour may run slightly
when wet, in particular during washing.
• Do not use solvents on the cover!
As one final check, make sure that the cover is correctly anchored in the
Keder rail, and that all fasteners and connectors are securely closed.
All of the cover parts, tube frame parts and plastic components on the
CONCORD WANDERER can be wiped down with a damp cloth.