Blue Ox BX88287 User Manual
Blue Ox For the car

BX88275 thru BX88285 and BX88287
EZ Light Wiring Harness Kit
Installation Instructions
405-0263 Rev B
Page 1 of 3
9/27/12
Installing the EZ Light
wiring harness system
requires basic hand-tool skills. Failure to
understand how to install or operate this product
could result in property damage and/or personal
injury.
Required Parts and Tools
•EZ Light Wiring Harness Kit
•Combination Wire stripper-crimper-cutter
•Screw drivers and/or wrenches and/or socket set
•Special tools to access the towed vehicle’s
taillight assemblies (depends on the vehicle.)
Installation Instructions
Driver side = Left side Passenger side = Right side
1) Find a convenient location to mount the control box that will allow the wiring harness to easily reach
the left and right tail lights. For instance, inside the spare tire well or behind an interior panel.
2) Gain access to the back of both the left and right tail light assemblies. This may be accomplished
from outside the vehicle or inside the vehicle depending on the make and model.
•Outside — remove the screws holding the tail light covers. Remove the covers and work the
taillight assemblies loose to expose the wiring.
•Inside — remove the plastic or fabric covering the assemblies to expose the wiring.
3) Plug the the wiring harness into the controller.
4) Route the DRIVER side wiring harness (yellow and brown wires in a bundle) to the DRIVER side
tail light wiring. Route behind interior panels as practical.
5) Route the PASSENGER side wiring harness (green and brown wires in a bundle) to the
PASSENGER tail light wiring. Route behind interior panels as practical.
6) Route the 4-wire FLAT cable to the front of the vehicle. Wire tie every 8 inches to 12 inches as
necessary to insure good mechanical connection to vehicle frame.
Bwn/Blk
Bwn/Blk
Yell/Blk
Grn/Blk
Bwn
Yell
Bwn
Grn