Blue Ox BX88255 User Manual

Page 3

BX88255

KarGard

Installation Instructions

405-0211 Rev C

Page 3 of 4

11/11/13

1. Using the 3/4” Socket and wrench,

replace the existing bolts of the tow bar

legs with the leg supports and 1/2”-13

essna jam nuts.

2. Slide the KarGard

II onto the receiver

tube of the tow bar, then install the tow

bar onto the towing vehicle per the tow

bar instructions. Extend the legs of the

tow bar until the leg support lines up to

the holes in the clamp brackets. Install

the 3/16” linch pins to secure together.

3. Hook up the tow bar to the towed vehicle

per the tow bar instructions. Slide the front

arm torwards the motorhome along the

receiver mount until the screen is tight, then

tighten the bolts on the underside to secure

in place.

4. When not in use, roll the KarGard™ II

up and secure with the attached velcro

strips.

Use an exhaust “turn down” to redirect the engine exhaust, if located directly below the

KarGard™ II. The KarGard™ II fabric may be warped or otherwise damaged if a turn down is

not installed, or if other exhausts which cannot be redirected are in close proximity to the fabric.