Blue Ox BX8870 - Manual (Page 12)

INSTALLATION FOR TOWING
1. Remove locking rod, unfold the KarGard and lock it
straight with the locking rod.
2. Install the towers into the tower bases. Pin them
in place with the spring lock pins.
3. Set the KarGard on the dowel pins (bottom first)
then install the hair pins to secure the KarGard in
place.
4. The KarGard is installed and ready for towing.
REMOVAL FOR STORAGE
1. Remove the hair pins and lay the KarGard flat. (angles
up) Replace hair pins to prevent loss.
2. Remove the towers from the tower bases. Place the
spring lock pins in the storage holes to prevent loss.
3. Store tower assemblies in slots in KarGard. Fold the
KarGard and insert the locking rod.
4. The locking rod at the hinged end serves as a handle.
BX8870
KARGARD TM
Product Safety Policy Statement
It is, and shall continue to be, a primary objective of Automatic Equipment Manufacturing Company
to provide customers with safe and reliable products. Automatic will, and has, established safety
procedures in product design, manufacture, promotion and sales; and will coordinate efforts to promote
customer safety to the greatest extent possible. Each department has primary responsibility for the
promotion of safety under the guidelines of the Product Safety Committee.
Repair parts may be ordered through your nearest
Automatic dealer or distributor.
TO BE VALID, THE WARRANTY CARD MUST BE
COMPLETED IN ITS ENTIRETY BY AN AUTHORIZED
DISTRIBUTOR OR DEALER AND SENT TO AUTOMATIC
EQUIPMENT MFG. CO., PENDER, NEBRASKA. FAILURE
TO DO SO WILL VOID THE WARRANTY.
QUICK REFERENCE GUIDE
Page 12 of 12 292-1813 Rev. E 4/20/09
© 1995, 2005, 06, 07, 08, 09 Blue Ox Division, Automatic Equipment Mfg. Co.
• One Mill Road, Industrial Park • Pender, Nebraska 68047
• Phone 402-385-3051 • Fax 402-385-3360 • www.blueox.us