beautypg.com

Caution, Disconnecting – Blue Ox BRK2010 User Manual

Page 12

background image

Disconnecting

Th

is section will provide disconnecting information about the Patriot®.

Perform these steps each time you remove the Patriot®.

1. Turn off the Patriot. Unplug the Patriot®’s power cord from the 12-volt accessory outlet.

2. Adjust the driver’s seat as far back as possible.

3. Unhook the brake bracket from the brake pedal. Unplug the Breakaway clips from the

Patriot® control panel (if applicable).

4. Lift the Patriot® out of the vehicle.

Shut off the unit and unplug the

RF when you stop driving for the

day. Don’t leave the unit plugged

in all night, it could drain your car

battery.

!

CAUTION

Page 13 of 16

405-0084 Rev. B

7/8/10

To satisfy FCC RF exposure requirements for mobile

and base station transmission devices, a separation

distance of 20 cm or more should be maintained

between the antenna of this device and persons

during operation. To ensure compliance, operation at

closer than this distance is not recommended.

The antenna(s) used for this transmitter must not be

co-located or operating in conjunction with any other

antenna or transmitter.

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy, and if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a
particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

Connect the equipment into an outlet on a

circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV

technician for help

These settings are GENERAL

GUIDELINES ONLY and may

vary depending on conditions,

driver and/or the vehicles involved

in your particular towing situation.

!

CAUTION