American Magnetics 430 Power Supply Programmer User Manual
Page 4
The Internet Protocol Model 430IP Power Supply Programmer
With no front panel controls except the power On/Off switch, the Model 430IP is designed for fully
functional magnet system control via the rear panel Ethernet connection using TCP/IP with a web browser.
Control can be established through a locally connected computer or remotely through a network or even the Internet; the
human/machine interface is a web browser depiction of the Model 430. This is especially useful for multi-axis systems where a
computer is an inherent part of the system. The IP-capable firmware can also be applied to the standard Model 430 with front
panel controls – in this case the computer-displayed Model 430 mirrors and controls all hardware front panel devices with the
exception of the ac input power switch. The following is a screen-shot of the Model 430IP being controlled with a web browser.
Selecting an AMI Power Supply System
Model 05500PS-430-601 System
Bipolar (Magnet Voltage -5 V
1
to +5 V)
05500PS-430-601
05300PS-430-601
05200PS-430-601
05100PS-430-601
0 A
100 A
200 A
300 A
400 A
500 A
1
Available for fast discharge of magnet.
Four Quadrant High Current (Magnet Voltage -6 V to +6 V)
4Q06250PS-430
4Q06125PS-430
-300 A -200 A
-100 A
0 A
100 A
200 A
300 A
Four Quadrant High Current (Magnet Voltage -12 V to +12 V)
4Q12125PS-430
4Q12125PS-430
-200 A
-100 A
0 A
100 A
200 A
Four Quadrant Low Current (Magnet Voltage -10 V to +10 V)
4Q1010PS-430
4Q061
25PS
4Q1005PS-430
-10 A
-5 A
0 A
5 A
10 A