Bosch Indego User Manual
Page 24
24 | English
F 016 L70 825 | (23.11.12)
Bosch Power Tools
Do not put hands or feet near or under rotating parts.
Never pick up or carry the machine while the motor is run-
ning.
Do not leave the machine to operate unattended if you
know that there are pets, children or people in the immedi-
ate vicinity.
Start the machine according to the instructions standing
well away from rotating parts.
Do not use the product at the same time as a sprinkler or
use the schedule to ensure that the two systems never run
simultaneously.
Do not modify this product. Unauthorized modifications
may impair the safety of your product and may result in in-
creased noise and vibration.
Remove the isolator key:
– before clearing a blockage,
– before checking, cleaning or working on the machine,
– if the machine vibrates abnormally (stop and check imme-
diately),
– after striking a foreign object. Inspect the machine for
damage and get advice on necessary repairs from your
Bosch Service Centre.
Maintenance and Storage
Always wear gardening gloves when handling or working
near the sharp blades.
Before working on the machine itself, remove the isola-
tor key.
Before working on the docking station or power supply,
remove plug from mains.
Clean the exterior of the machine thoroughly using a soft
brush and cloth. Do not use water, solvents or polishes. Re-
move all grass and debris, especially from the ventilation
slots.
Turn the machine on its back and clean the blade area regular-
ly. Use a stiff brush or scraper to remove compacted grass
clippings. (see figure A)
Blades are reversible. (see figure B)
Keep all nuts, bolts and screws tight to be sure that the ma-
chine is in safe working condition.
Periodically visually inspect the machine and replace worn
or damaged parts for safety.
Ensure that only official Bosch replacement parts are used.
Replace all blades and bolts as a set as required.
Storage
Remove isolator key when storing.
During winter season store the machine and the docking sta-
tion in a secure, dry place, out of the reach of children.
Do not place other objects on the machine or docking station.
SD-Card
The machine has a SD-Card interface to allow software diag-
nosis by a Bosch Service Centre.
Battery Hazards
Recharge only in the Bosch approved docking station.
In the unlikely event of liquid being ejected from the bat-
tery avoid all contact with the machine. If contact with the
liquid occurs, seek medical advise.
If the battery becomes defective, liquid can escape and
come into contact with adjacent components. Check any
parts concerned and contact the Bosch Service Centre.
Do not open the machine and battery inside. Danger of
short-circuiting and electric shock.
Protect the machine against fire. Danger of battery ex-
plosion.
In case of damage and improper use of the machine, va-
pours may be emitted from the battery. Provide for
fresh air and seek medical help in case of complaints.
The vapours can irritate the respiratory system.
Store the machine only within a temperature range between
5 °C and 45 °C. As an example, do not leave the machine in
the car in summer.
Safety Warnings for Docking Station and Power
Supply
Only charge via the official Bosch docking station. Oth-
erwise there is danger of fire and explosion.
Check the docking station, power supply, cables and
plugs periodically. If damage is detected, do not use
the docking station or power supply. Never open the
docking station or power supply. Have repairs per-
formed only by a qualified Bosch technician and only
using original spare parts. A damaged docking station,
power supply, cable or plug increases the risk of an electric
shock.
Do not operate the docking station and power supply
on easily flammable surfaces (e. g., paper, textiles,
etc.) or surroundings. The heating of the docking station
and power supply during the charging process can pose a
fire hazard.
Supervise children at all times. This will ensure that chil-
dren do not play with the docking station, power supply or
the machine.
Children or persons that owing to their physical, senso-
ry or mental limitations or to their lack of experience or
knowledge, are not capable of safely operating the
docking station or power supply, may only use this
docking station and power supply under supervision or
after having been instructed by a responsible person.
Otherwise, there is danger of operating errors and injuries.
The voltage indicated on the power supply must corre-
spond to the voltage of the power source.
The power supply should ideally be connected into a socket
that is protected by a circuit-breaker that is actuated by a
30 mA residual current. Check your Residual Current Device
(RCD) at regular intervals.
The supply cord must be inspected for signs of damage at reg-
ular intervals and may only be used if in perfect condition.
OBJ_BUCH-1573-003.book Page 24 Friday, November 23, 2012 9:10 AM