Appendix – Garmin GPSMAP 130 User Manual
Page 79
To flush mount the GPSMAP 130:
1. Cut a 4.15” W x 4.67” H (105.4 x 118.6mm) hole in panel.
2. Place GPSMAP 130 into hole from the front until its flange rests against
the mounting surface.
3. From the back side of the panel, loosely attach the bracket so that the slot in the ratchet
area points away from the mounting panel.
4. Rotate the bracket downward until the panel is pinched tightly between the unit’s flange
and bracket lobe.
5. Tighten knobs and connect the power/data and antenna cables.
WARNING!
The temperature range for the GPSMAP 130 is -4 to
+158ºF (-20 to 70ºC). Extended exposure to temper-
atures exceeding this range (in storage or operating
conditions) may cause failure of the LCD screen. This
type of failure and related consequences are NOT
covered by the manufacturer’s limited warranty.
69
SECTION
A
APPENDIX
Installation
gps 130 7/23/98 9:23 AM Page 69