Binatone MRFP-8807 - Manual (Page 6)

6
6. Rubber feet
7. Adapter
8. Actuator
9. Dough kneading tip
10.Mincer
11.Double-sided tip with a coarse grate for coarse shredding
12.Double-sided tip with a fine grate for fine shredding
13.Knife for cutting French fries
14.Blade
BEFORE USE
Before the first use of the appliance, thor-
oughly wash all components which will contact
with food products. Wipe with a soft damp cloth
the casing (4) of the appliance.
OPERATING INSTRUCTIONS
1. Put the cup (3) on the appliance casing (4).
Fix the kitchen machine cup (3) by turning coun-
terclockwise up to the stop.
2. Fix the required tip in the cup (3): use the
adapter (7) which is mounted on the actuator
(8) for the shredders (11, 12, 13); for the tips
(9, 10), the adapter (7) is not required.
3. Close the cup (3) with the lid (2). Turn the lid
counterclockwise and match the mark on the lid with the arrow
of the cup handle. Make sure that all components of the appli-
ance are properly installed. If the cup (3) or the lid (2) are
installed improperly, the appliance will not switch on.
4. Load the food products through a special loading opening in
the lid (2). Use the pushrod (1) for pushing products through
the loading opening. During the operation, you may use the
pushrod (1) to cover the loading opening to prevent the splash-
out of liquid or food product chips.
Attention: if the kitchen machine suddenly stopped
operating, press the knob «0» to switch off the
appliance, unplug the appliance from the power grid
and allow it cool down within 15 minutes. After
that, switch it on again.
5. Use the mode selector (5) to choose the required mode of
operation («I» or pulse «Pulse»). After completion of the work,
press «0» to switch the appliance off, and unplug the power
cord from the power grid.
6. The appliance mills the products very quickly. To avoid exces-
sive milling of ingredients, each time switch on the appliance
for a short period of time.
7. Use mode «I» either for grating soft vegetables and fruit, or
slicing solid products. Use the pulse mode («Pulse») for milling