SUUNTO Vyper2 - Manual (Page 12)

ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
4.1.4. Setting the units
In the UNITS SETTING mode you can choose to have the units displayed in either the
metric or imperial system - meters/feet, Celsius/Fahrenheit etc.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
4.1.5. Setting the backlight
Use the BACKLIGHT SETTING mode to turn the backlight on or off and to define how
long it stays on for (5, 10, 20, 30, or 60 seconds). When the backlight is turned off, it does
not illuminate when an alarm sounds.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
4.1.6. Setting the tones
The TONE SETTING mode allows you to activate or deactivate the tones.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
NOTE When the tones are off, there are no alarms.
4.2. AC water contacts
The water and data transfer contact is located on the rear of the case. When submerged,
the water contact poles are connected by the conductivity of the water and the “AC” symbol
appears on the display. The AC text is shown until the water contact deactivates.
12