Acura 2013 TSX - Manual (Page 283)

uu If a Tire Goes Flat u Changing a Flat Tire
282
Han
d
lin
g the U
n
expected
1. Remove the center cap and place the flat
tire face down in the spare tire well.
2. Remove the spacer cone from the wing
bolt, flip it over, and insert it back on the
bolt. Secure the flat tire with the wing bolt.
3. Securely put the jack and wheel nut
wrench back in the tool case. Store the case
in the trunk.
If you replace a flat tire with the spare tire, the low tire pressure/TPMS indicator
comes on while you are driving. After driving for a few miles (kilometers), the
indicator will start blinking for a short time and then stay on. CHECK TPMS
SYSTEM appears on the multi-information display, but this is normal.
If you replace the tire with a specified regular tire, the warning message on
■ Storing the Flat Tire 1 Storing the Flat Tire
3 WARNING
Loose items can fly around the interior in a
crash and can seriously injure the
occupants.
Store the wheel, jack, and tools securely
before driving.
Spacer
Cone
Wing
Bolt
For
compact
spare tire For
normal
tire
■ TPMS and the Spare Tire 1 TPMS and the Spare Tire
The system cannot monitor the pressure of the spare
tire. Manually check the spare tire pressure to be sure
that it is correct.
Use TPMS specific wheels. Each is equipped with a
tire pressure sensor mounted inside the tire behind
the valve stem.
13 ACURA TSX 4D-31TL16400.book 282 ページ ２０１２年７月２７日 金曜日 午前１１時３１分
QRG
Index
TOC
2013 TSX
the multi-information display and the TPMS indicator will go off after a few
miles (kilometers).