Training a button – Acura 2013 TSX User Manual
Page 167

uu
HomeLink® Universal Transceiver
u
Training HomeLink
166
Features
■
Training a Button
1
Training HomeLink
Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:
Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.
If you have any problems, see the device’s
instructions, visit www.homelink.com, or call
HomeLink at 1-800-355-3515.
1. Press and hold the desired HomeLink button until the
HomeLink indicator begins to blink.
2. Continue to hold the HomeLink button and follow steps
1 - 3 under “Training a Button.”
Indicator remains on for
about 25 secs.
Standard transmitter
Indicator blinks rapidly for
two secs, then remains on
for about 23 secs.
Rolling code transmitter
1.
Position the remote transmitter you wish to link 1 to 3 inches (3-8 cm) from the HomeLink
button you want to program.
2.
3.
Press and hold the desired HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink after 10 secs?
Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?
a.
4.
5.
a.
b.
Training
Complete
Press and hold the
HomeLink button again.
The remote-controlled
device should operate.
The remote has a rolling code. Press the
“learn” button on the remote-controlled
device (e.g. garage door opener).
Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.
Press and hold the HomeLink button again.
Training Complete
NO
Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.
Dose the LED blink within 20 secs?
NO
YES
YES
NO
HomeLink LED
is on.
HomeLink indicator blinks for 2 secs,
then remains on.
YES
13 ACURA TSX 4D-31TL16400.book 166 ページ 2012年7月27日 金曜日 午前11時31分
QRG
Index
TOC
2013 TSX