beautypg.com

Training a button – Acura 2011 TSX Sport Wagon User Manual

Page 176

background image

174

Fe

atu

re

s

HomeLink

®

Universal Transceiver Training HomeLink

Training HomeLink

Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:

Training a Button

1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the

HomeLink button you want to program.

2. Press and hold the desired HomeLink button and the button on

the remote transmitter.

Does the HomeLink indicator (LED) blink after 10 secs?

3. Press and hold the

programmed HomeLink
button for about a sec.

Does the device (garage

door opener) work?

a. Press and hold the remote and the HomeLink

button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.

Does the LED blink within 20 secs?

4. Press and hold the HomeLink button again.

a. The remote has a rolling code. Press the

"learn" button on the remote-controlled
device (e.g. garage door opener).

b. Within 30 secs, press and hold the

programmed HomeLink button for 2 secs.

5. Press and hold the

HomeLink button again.
The remote-controlled
device should operate.

Training Complete

Training

Complete

YES

YES

NO

NO

NO

YES

Erasing Codes
To erase all the codes, press and hold the two
outside buttons until the HomeLink indicator begins
to blink (about 10 to 20 secs). You should erase all
codes before selling the vehicle.

If you have any problems, see the device's
instructions, visit www.homelink.com, or call
HomeLink at (800) 355-3515.

1. Press and hold the desired HomeLink button

until the HomeLink indicator begins to blink.

2. Continue to hold the HomeLink button and

follow steps 1 - 3 under "Training a Button."

HomeLink LED

is on.

HomeLink indicator blinks for 2 secs,

then remains on.

Indicator remains on
for about 25 secs.

Standard transmitter

Indicator blinks rapidly for
two secs, then remains on
for about 23 secs.

Rolling code transmitter

31TL7600.indb 174

2010/09/10 15:19:29

This manual is related to the following products: