Acura Embedded AcuBrite 15″ - Manual (Page 3)

AcuBrite™ Manual User’s Manual
Introduction
Welcome to a fantastic sightseeing world. This new technology
will bring you a whole new feeling about LED “monitor”. We
show here some of the major advantages of the Acubrite™
15"touch screen high bright LED back-lit monitor.
Hardware Installation
This section will guide you through the correct installation
procedures of the monitor.
Unpacking
After you unpack your LED Monitor, please make sure that the
following items are included in the carton and in good condition.
If you find that any of these items are damaged or missing,
please contact your dealer immediately.
 Acubrite™ 15" touch screen LED monitor
Page 1
 Cable (VGA, USB, Serial, Audio)
Standard - 12’ cable
(Optional. 6’,10’ & 15’
available! Contact your
dealer if you require
optional length.)
 Power
cable
Yellow/G --- Ground
Blue --- Ignition
Brown --- +12V Input
Pin 1& pin 3 --- Power
Pin 2 --- Ground
Pin 4 --- Ignition
Cautions:
Operating: Use IGNITION wire feature where possible.
No ignition control desired: twist, join, power
and ignition wire together.
Turn off monitor when leaving vehicle.
Do not place over hot areas e.g., Vents.
Clean regularly, annually at a min.
Page 2