Acumen AiP-T53N - Manual (Page 8)

7
Chapter 2 Before Accessing AiP camera
Before accessing the AiP camera, make sure that the
camera’s RJ-45 network
cable, audio cable, and AiP camera
’s power cable are properly installed. For
setup IP address, please consult your network administrator for available IP
addresses. The default IP address of AiP camera is 192.168.0.200. User can
also use default IP address to verify AiP camera
’s network connection.
Chapter 2-1 Configure IP Address Using IPScan Utility
To configure IP address using IPScan utility, copy IPScan application from
installation CD to your local PC or execute IPScan software from installation CD
directly. IPScan utility can also be downloaded from our company web site. To
change IP address, subnet mask, gateway, or HTTP port, please follow steps
below:
 Run IPScan utility.
 Click on Refresh button. All available devices get listed in Device list box.
 Select the device item in Device list box.
 Edit or modify addresses in IP, Subnet Mask, Gateway, or HTTP Port edit box.
 Click on Apply button to configure the settings.
 Click on Refresh button to verify the settings.
Note: Make sure that IPScan is version 1.0.0.31 or above.