Actron PocketScan Plus CP9550 - Manual (Page 9)

9
The Tool will indicate Ready, Not Ready, or Not Applicable for each I/M
Monitor. The Tool supports the following I/M Monitors:
Monitors Expanded Name
Misfire Monitor Misfire Monitor
Fuel System Fuel System Monitor
Comprehen Comp Comprehensive Components Monitor
Catalyst Catalyst Monitor
Htd Catalyst Heated Catalyst Monitor
Evaporateve Sys Evaporative System Monitor
Second Air Sys Secondary Air System Monitor
A/C Sys refrig Air Conditioning Refrigerant Monitor
Oxygen Sensor Oxygen Sensor Monitor
Htd 02 Sensor Oxygen Sensor Heater Monitor
Exhaust Gas Rec Exhaust Gas Recirculation
This is a complete list of I/M Monitors supported by the Tool. The number
of Monitors read by the Tool from your vehicle may vary. A diesel vehicle,
for example, does not have an Oxygen Sensor Monitor. As a result,
there will be no Oxygen Sensor Monitor status for a diesel vehicle.
Freeze Frame Data
Displays a snapshot of operating conditions at the time the Diagnostic
Trouble Code was created.
VIN
The VIN (Vehicle Indentification Number) function allows the Tool to
request the VIN. The VIN is the factory-assigned vehicle serial number.
This function is available on model year 2000 and newer vehicles.
The VIN is located on top of the dashboard on the driver’s side, vis-
ible from outside the car. The VIN includes information about the car,
including where it was built, body and engine codes, options, and a
sequential build number.
The vehicle computer module uses the VIN number to determine which
Diagnostic Codes to use. To ensure that the Tool is providing the most
complete information for your vehicle, confirm that the VIN reported
by the vehicle computer module matches the VIN of the vehicle being
tested. The numbers should be the same unless the computer module
had been swapped out.