E - p e n, O w t o, O u r – Activeforever Verseo ePen Permanent Hair Removal System User Manual
Page 9
F
A C E
T
R E A T M E N T
•
Thoroughly clean treatment area as described on Pre-treatment (Page 7).
•
Cut the cotton bud/Q tip in half and insert. The cotton bud/Q tip should sit against gold
ring with stem fully inserted.
•
Dip cotton bud/Q tip into the conductive gel making sure that gel also covers the gold
cotton bud/Q tip holder at the front of the control unit. Cotton bud should NOT now
fall out. This ensures that the cotton cotton bud/Q tip is fully conductive.
(See diagram 1)
•
Hold
e
-PEN the following way (see diagram 2).
•
Slide the switch to the
PROBE
position.
(Check red power light is on to confirm battery is working).
•
When touching the treatment area, green
conductive light
must light up, if not put more conductive gel
onto cotton bud/Q tip and gold cotton bud/Q tip
holder.
•
The Gold cotton bud/Q tip holder can be easily
removed for cleaning (see diagram opposite).
Simply insert nail between plastic and gold tip
holder, and pull out. Rinse in warm water to
remove surplus gel.
T
R E A T M E N T O F
F
I N E
F
A C I A L
H
A I R S
Apply cotton bud/Q tip to treatment area, press activator gold button to commence 20
second treatment time. Touch gel with the cotton bud/Q tip. Green conductivity LED light
will come on. If you do not touch the gel continuously - the green conductivity light will go
out.
e
-PEN automatically resets itself when good contact is made. The automatic timer
buzzes when the 20-second treatment time is finished and resets itself for the next
treatment. Once the gold button is released the conductivity stops. Repeat the process for
the next treatment area. Remove the treated hair with
e
-PEN Tweezers provided.
Maximum Use: DO NOT EXCEED one 20 second treatment per day in one treatment area
- 2cm diameter. Maximum of 3 treatments per week in one treatment area.
8
H
O W T O
U
S E
Y
O U R
E - P E N
P
E R M A N E N T
H
A I R
R
E M O V A L
S
Y S T E M
•
PROBE
•
OFF
•
FACE PAD
•
BODY PAD
ePEN_Instruction6_04 6/16/04 1:55 PM Page 9