Activeforever Teeter Hang Ups EZ-Up Inversion System - Manual (Page 2)

Step Three
Install the CV Bar
• Insert the CV Bar into the ankle clamp housing.
• Attach the CV Bar by inserting the bolt removed in Step Two through the holes located at the
front of the ankle clamp housing (just under the locking pin). (See Figure 3)
• Securely tighten the nut and bolt with wrenches.
• With the CV Bar in place, you may choose to remove the locking pin by unscrewing its base.
Be sure to keep it in case you want to re-attach the ankle clamps in the future.
Figure 3
Assembly & User Instructions LB-1007 Pg. 2
Calf Loops are an optional feature that are easily detachable (removing the calf loops may make the
Gravity Boots more comfortable for shorter adults and children). Calf Loops provide the following
benefits:
1. Reduce loads on the ankles and prevent the front edge of the boot from placing uncomfortable
pressure on the top of your feet.
2. Place a 2° bend in the knees, which for most people is more comfortable than inverting with
straight legs.
Calf Loops: Why use them?
TO ATTACH CALF LOOPS:
Insert the base of the Calf Loop into the open end of the Boot Hook (Figure A). Make sure you
hear the Calf Loop snap into place - this indicates secure attachment. Repeat on other boot.
TO DETACH CALF LOOPS:
Press your finger onto the Calf Loop Release Tab (Figure B) and pull loop away from the Boot
Hook.
* Calf Loops must be attached/detached while the Gravity Boots are NOT being worn.
Boot Care:
No regular maintenance is required. However, we recommend keeping the buckles latched when
not in use to prevent possible damage.
GRAVITY BOOTS:
ATTACHING / DETACHING THE CALF LOOPS
B.
Step Two
Remove the front ankle clamps
• Remove the bolt that holds the retainer spring attached to the front ankle clamp. (See
Figure 2) Keep the bolt and nut for use in Step Three.
• Pull up on the locking pin and remove the front ankle clamp assembly and spring.
Figure 2
ASSEMBLING THE CV BAR (cont.) SECURING THE GRAVITY BOOTS
A.
Check to be sure the CV Bar is properly secured prior to inverting. Failure to do so
may result in serious injury or death!
WARNING !