Activeforever Signature Series Electronic Stethoscope Adult Black (Adult, black) - Manual (Page 4)

POWERING UP
To turn the Electronic Stethoscope on:
1. Press the “+” button located at the bottom of the Control Center.
2. The green and orange lights will flash three (3) times.
3. The Mode and Volume level will be set at the setting previously used prior
to the Electronic Stethoscope being turned off.
CHANGING VOLUME
Eight (8) volume levels can be selected in each Mode.
Press the “+” button to raise volume level.
Press the “-” button to lower the volume level.
1. While in the Bell (Orange) Mode, the orange light will flash once to
indicate a change in the volume level.
2. While in the Diaphragm (Green) Mode, the green light will flash once to
indicate a change in the volume level.
3. While in the Extended (Yellow) Mode, the yellow light will flash once to
indicate a change in the volume level.
4. Adjust the volume to minimum (1) or maximum (8) by sound.
AUTO SHUT OFF
To extend the battery life, your Electronic Stethoscope comes with an auto-off
function that will automatically turn the unit off after approximately 100 sec-
onds after the last keyed operation.
To deactivate this feature, press the “-” and “M” button simultaneously for
approximately three (3) seconds. The Yellow and Orange lights will flash three
(3) times to indicate that the auto-off feature has been disabled.
CHANGING MODES
Frequency Modes are identified by the following lights:
Yellow Extended Range
Orange Bell
Green Diaphragm
To change Modes:
1. Press the “M” button to select the next frequency mode.
2. Modes will change sequence as follows:
Yellow
→
Green
→
Orange
→
Yellow
Using Your Stethoscope
FUNCTION BUTTON PRESS BUTTON VOLUME LEVELS FLASHES
ADJUST
VOLUME
“+” or “-” ONCE 1-8
MODE LIGHT
FLASHES
ONCE
FUNCTION BUTTON
PRESS
BUTTON
DISPLAY FLASHES
MODE change “M” Once Yellow
→
Green
→
Orange
→
Yellow
Mode light
changes in
sequence
5 6
91-032-400 Instruction Manual 8/30/07 8:36 AM Page 7