Acroprint BP125 "BOSS" - Manual (Page 2)

Battery Powered Clock User Instructions
Acroprint Model 125 Time Clocks
Acroprint Time Recorder Company, 5640 Departure Drive, Raleigh, NC 27616
PHONE 919-872-5800 IN USA 800-334-7190 FAX 919-850-0720
06-0106-000 Rev. K
Figure 2
BP125-R6: 6-Volt Rechargeable Time Clock
BP125-R6 Recorder includes four (4) rechargeable
batteries.
IMPORTANT: Before setting the recorder, plug the
machine in for at least 15 minutes to allow the batteries
to charge to operating voltage.
125 Rechargeable (120V/240V AC)
BP125-12: 12-Volt Battery Powered Time Clock
The BP125-12 Recorder is designed to operate from a
12 Volt DC automobile battery. Acroprint recommends
the recorder be connected directly to the Battery to
insure a constant power supply.
Supplied are two (2) “ring” terminals for the battery
connection and two (2) “Y” terminals for connection to
the recorder terminal block.
You will need two (2) wires cut to the proper length for
your application. Acroprint recommends No. 20 gauge
stranded copper wire for this application.
BP125-12 Installation:
• Connect a “ring” terminal to one end of each
wire and a “Y” terminal to the other end.
• Locate the six (6) position terminal block
mounted to the time recorder’s back case.
• Connect one “Y” terminal to terminal No. 1 of the
terminal block and the other end to ground.
• Connect the other “Y” terminal to terminal No. 2
of the terminal block and the other end to the
positive battery post.
Note: The wires can be run through the firewall of a
vehicle using an existing opening for air conditioning or
heater hoses. If necessary, you may drill a hole in the
firewall at a place where there are no obstructions under
the hood. The unit can be professionally installed by a
garage specializing in automobile electrical services.
125 Battery Powered (12V DC)
Connector
Improper Battery
Insertion Indicator
(4) 1.25v D-Size
Rechargeable Batteries
12v DC
Battery