ACR&Artex Float-Free 406 Memory Capsule - Manual (Page 15)

Y1-03-0199 Rev. E 12
The installation step is placing the data transfer cable inside the cutter mechanism. Remove the top screw from the
flex cable slot and open the white door (see Figure 10). Slide the data transfer cable
along the side of the cutter
mechanism and into the slot as shown above. Close the flex cable slot door and secure shut with by replacing the top
screw.
Final Installation Steps:
Now the memory capsule is armed and ready for service.

Place the protective top cover on the memory capsule, placing the bottom clamp through the top cover
opening on the bottom and the secure the top closed by placing the cotter pin thru the hydrostatic release
rod.

Connect the Cat. 5 cable to your S-VDR unit and ensure that the S-VDR unit is communicating properly
with your float free 406 memory capsule. Consult your technical
user’s guide for proper installation to your
S-VDR.
4.3
Visual Inspection
Visually inspect the area surrounding the installation site for hidden hazards, obstacles, etc., that may have been
overlooked during selection. If there is any doubt as to the ready accessibility to the memory capsule at all times or if
any condition may appear to be questionable, make a complete and thorough investigation before making final
approval of the installation.
4.4 Important Expiration Dates
The label on the hydrostatic release mechanism inside of the bracket and the replacement date label on the outside of
the bracket MUST be marked with the date of expiration at time of installation according to coastal marine authority
regulations.
To record the expiration date on the hydrostatic release mechanism, with a permanent indelible marker mark off the
dates to indicate the month and year two years from date of installation. Write the date of expiration with an indelible
marker on the label appearing on the outside cover.
Data Transfer Cable in Cutter
Figure 10