Pc 5153 – Acnodes PC 5153 User Manual

Page 28

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 5153

15” Industrial wireless Panel PC

4.5 JUMPER SETTINGS

NOTE:

A jumper is a metal bridge that is used to close an electrical circuit. It consists of two

metal pins and a small metal clip (often protected by a plastic cover that slides over

the pins to connect them. To CLOSE/SHORT a jumper means connecting the

pins of the jumper with the plastic clip and to OPEN a jumper means removing the plas-

tic clip from a jumper.

The following jumpers can be found on the motherboard installed in the PC5153/

PC5173. Before thePC5153/ PC5173 is installed, the jumpers must be set in accor-

dance with the desired configuration. The jumpers on the PC5153/ PC5173

motherboard are listed in Table 4-1.

4.5.1 ACCESS THE JUMPER

To access the jumpers, remove the back panel. To remove the back panel, please refer

to Section 4.4.