Acnodes FPC 5105 - Manual (Page 44)

4.2 Touch Screen
The FPC5105 uses the 5-wire analog resistve. There are the specification and driver
installation which are listed below.
4.2.1 Specification
Touch Screen
5-wire Analog Resistive type
Touch Screen Controller
PenMount 6000 USB Touch Screen Controller IC
Communications
USB interface
Baud Rate
19200 baud rate fixed
Resolution
800 x 600 (10 bit A/D converter inside)
Power Input
5V
Power Consumption
Active: 24.6mA / Idle Mode: 13.4mA
4.2.2 Driver Installation- Windows 7
The FPC5105 provides a touch screen driver that users can install it under the operating
system W indows 7. To facilitate installation of the touch screen driver, you should read the
instructions in this chapter carefully before you attempt installation.
1. Insert Driver CD and follow the path to select the “\Drivers\Step 5 - Touch”.
2. Follow the installing procedure and press OK.