Acme BH-02 - Manual (Page 4)

4
EN
trouBlesHootIng
If you cannot connect the headset to your phone, do as follows:
• ensure that the headset is charged, switched on, paired with and connected to
your phone.
• ensure that the Bluetooth feature is activated on your phone.
• check that the headset is within 10 meter (30 feet) of your phone and that there
are no obstructions between the headset and the phone, such as walls or other
electronic devices.
BAsIc use
cAll HAndlIng
To Make a call
use your phone in the normal way when the headset is connected to your phone.
To aNswer a call
Press the Answer/end key, or use the phone keys. If the automatic answer function
is set on, the phone automatically answers the incoming call after one ring.
To eND a call
Press the answer/end key or use the phone keys.
redIAl tHe lAst dIAled nuMBer
Press and hold volume up (Δ) key for 3 second to redial the last dialed number (if
your phone supports redialing with this device).
voIce dIAlIng (dIAlIng A nuMBer BY sAYIng A nAMe)
It is possible to make a call directly from the headset using voice recognition. to
use this voice dialing function, your mobile phone must provide this option and
corresponding voice samples must have been recorded.
Step-1
Press the Answer/end button of the headset one time, you will hear a beep prompt.
Step-2
when you hear a short tone, say the name of the person you wish to call loudly.
Adjust tHe eArPHone voluMe
VoluMe uP
while in conversation, press the volume up (Δ) button to increase the volume.
VoluMe DowN
while in conversation, press the volume down (∇) button to decrease the volume.
Adjust tHe MIcroPHone voluMe
If you want to mute the microphone, press and hold volume down (∇) button for
3 second till you hear a beep. release the button and the microphone is muted.
when microphone is muted you hear sort beep signals from BH02 earphone. If you
want to unmeet the microphone, press and hold volume down (∇) for 3 second
again till you hear a beep.
swItcH tHe cAll Between PHone And HeAdset
during a conversation, press and hold the Answer/end button for 3 seconds, the
BH02 will be switched off and the call will be transferred to your mobile phone. If