Accusys ExaSAN SW08-Q4 User Manual
Page 9

Follow these steps to install the card in each host system:
1. Hold the HBA with mounting plate facing your left.
Locate the “mode” jumper switch on the north edge at
center-right, as shown and labeled below.
2. This HBA card can be used both in DAS and SAN
applications, whether or not the HBA card was just
purchased or originally used in storage. In this case,
the HBA card is used for connecting the Compact
Switch. Please make sure the switch button is toward
the “1” position, as shown below.
3. Position the connector of the card over the slot, insert
the connector into the slot, press gently but firmly until
it is securely seated.
4. Secure the metal bracket of the card to the system
case with a screw.
5. Replace the outer casing cover.
User Guide
P7