Hardware installation – Accusys ExaSAN SW08-Q4 User Manual
Page 4

User Guide
P2
1.Hardware Installation
Congratulations on your purchase of the “Accusys ExaSAN SW08-Q4 Solution” SAN (Storage Area Network)
system solution. This User Guide gives you step-by-step setup instructions of a basic system configuration. Our
sample configuration consists of one RAID 12-bay disk system, one SW08-Q4 switch. Figure 1 below depicts our
sample ExaSAN Solution setup.
FIGURE 1. Sample ExaSAN Solution Architecture
Although it is not practical to cover all possible scenarios in this guide, most variations of the system configuration
can be derived from this sample. If your particular installation encounters a problem that is beyond the scope of
this guide, please contact our technical support staff for assistance.
( User requires a system with DDR2 2GB.)
SW08-Q4
Switch
MDC server
Client (up to 7)
A12S2-PS
RAID Controller
(up to 4)
ConnectionLink
QSFP link (A12S2-PS to SW08-Q4)
QSFP link (SW08-Q4 to Client)
Internet