Acclaim Lighting Catwalk Panel - Manual

CAT WALK PANEL is a wonderful LED display screen integral with 25 three-in-one RGB LEDs, featuring auto
DMX addressing and inductive touch control.
FEATURES
225g WEIGHT
60ms Min INDUCTIVE TIME
20mm Max INDUCTIVE DISTANCE
40mm PIXEL DISTANCE
6A MAX CURRENT INPUT
24VDC OPERATING VOLTAGE
Full color 5050 SMD LEDs (25pcs) LIGHT SOURCE
450mA CURRENT CONSUMPTION
200(L)x200(W)x10(H)mm DIMENSIONS
USER'S GUIDE
- Automatic DMX addressing
- Innovative control by inductive touching
- Easy & one-for-all setting
- Dazzling LED display suitable for various occasions
- Remarkable interactive lighting-up to walking or dancing
CAT WALK PANEL
SPECIFICATIONS
INSTALLATION & OPERATION GUIDE
1 Field Connection
NOTE:
Connect the first unit to the 24VDC power supply (and a DMX controller, if necessary). Then link other units
to it in a line by using the power/data cables. Up to 24 units can be linked together by DMX1000K and 6 units
by DMX512.
i) The nominal wattage of the power supply in use must be above the loading of the whole line of units,
otherwise extra power supplies will have to be used, so as to avoid risk of over-loading.
Ii) The maximum permissible current of the power/data cable is 6A. Always keep input current below 6A.
3 Auto DMX Addressing
When are linked together and controlled by a DMX protocol, CAT WALK PANEL units DMX channels will be
automatically addressed in numeric order (D1 ~ D25), starting from red, green and then blue section of the
first LED (position designator - D1) of the first unit. This means a single unit shall takes 75 DMX channels of
which each three channels are assigned to one LED (1st channel for red, 2nd for green and 3rd for blue).
2 Inductive Control
When the units are duly connected and powered, and an object eg finger, foot, etc comes within the
inductive range of the LEDs of a unit, the LEDs will automatically change from background color (manually
preset or DMX controlled) to touch-color, and turn back to background color when the object goes out of the
inductive range,.
4 How to Get the Unit Ready for Use
Start Setting
Turn on the LEDs one by one with a finger or similar object along the track indicated in Fig 1. Follow the track
a second time and then make the finger stay at LED D13 (the central one) till all the LEDs start twinkling,
which means the unit now has moved into setting mode and has been ready for further setting.
PRODUCTION DESCRIPTION