Acclaim Lighting ART 8D - Manual (Page 5)

6
Key tone
This device allows you to switch the key tone to ON or OFF.
Press the button 1,2 ,3 and 4 at the same time to switch the
key tone between ON and OFF.
DMX Address setting
The DMX initializing address for the 8 channels can be set via
the dip-switch on the rear panel of this unit. each dip switch
represents a binary value.
DMX Address Setting
1 2 3 4 5 6 7 8 9 10
Off
On
Dip-switch #
(256)
(128)
(64)
(32)
(16)
(8)
(4)
(2)
(1)
DMX Address Table
DMX
START
CH#
DIP-SWITCHS
ON
1
14
15
16
:
:
:
511
2, 3, 4
1, 2, 3, 4
5
:
:
:
1,2,3,4,5,6,7,8,9
2
3
4
5
6
7
8
9
10
11
12
13
1
2
1, 2
3
1, 3
2, 3
1, 2, 3
4
1, 4
2, 4
1, 2, 4
3, 4
1, 3, 4
DIP-SWITCHS
ON
DMX
START
CH#
Here are the DMX Address Setting diagram and Dmx Address
for matching with the dip switches for your reference.
3
Press the power switch for 3s to activate the SwitchOFF Fade-
Time mode, the back light of figure button 1-8 and M1 button
will blink, select a figure within the range of 1-8 to set the
SwitchOFF Fade-Time value as the corresponding selected
figure.
If you want to edit other scenes, press the corresponding figure button for 3s, Note:
and repeat step2 to step 7 to accomplish the setting.
Press power switch and scene1 button to exit the programming
mode.
2. Programming Mode2
When this unit is programmable, press M1 button and any figure button between 1to 8 for 2s
to save the current channel DMX values to the corresponding scene.
Other ways to set the Fade-in-time and Switch Off fade-time
Way A
Step1. Keep pressing the M2 button(invisible) for 2s to activate the
Fade-in-time mode.
Step2. Press a figure button selected between 1 to 8, press it once,
the value will be set as the corresponding figure. For example,
press figure button 5 once, the Fade-in-time value is set as 5s;
Step 7.
Step 7.
!
Step 8
Step 1.