Candy PVU 647 X - Manual (Page 27)

25
Before starting to clean your oven, be sure that all controL knobs are off and your appliance
is cooled off. Unplug the a liance.
Do not use cleaning materials containing particles that might scratch the enamelled and
painted parts of your oven. Use cream cleaners or liquid cleaners, which do not contain
particles.
As
they might harm the surfaces, do not use caustic creams, abrasive cleaning powders,
rough wire wool or hard tools. In the event the excess liquids spilling over your oven
should burn, it may cause a damage to the enamel. Immediately clean up the spilt liquids.
Do not use steam cleaners for cleaning the oven.
PART 5 : CLEANING AND MAINTENANCE
Make sure to unplug the oven before starting to clean it. You will obtain best results if you clean
the oven interior while the oven is slightly warm. Wipe your oven with a soft piece of cloth
dampened with soap water after each use. Then wipe it again, this time with a wetted cloth, and
wipe it dry. A complete cleaning may be necessary from time to time, using a liquid
cleaning material. Do not clean using dry and powder type cleaners. For products with catalytic
enamel frames, the rear and side walls of the inner frame do not require cleaning. However;
depending on usage, it is recommended that you replace them after a certain period
of time.
ENG
5.1 GENERAL
5.2 CLEANING THE OVEN
pp
Unplug the appliance before starting the cleaning.
Wait for the vitroceramic glass to completely cool off before starting the cleaning.
Make sure that the cleaning materials you will use do not contain particles that might scratch
t e glass Use cream detergents or liquid detergents .
The vitroceramic surface should be wiped with cold water and wiped dry with a soft piece
until no cleaning material is left on the surface.
You can use the cleaning spatula supplied together with your product, for the cleaning of spilt
foods and residue .
Dessert type of foods should be cleaned immediately after they spill without waiting for the
vitroceramic glass to cool off.
5.3 CLEANING THE VITROCERAMIC HOB
of cloth
if ,
h
s.
Scrubbing with steel cleaning wires may harm the vitroceramic glass surface. Formations of dust
on the surface should be cleaned up using a dampened cloth .
Changes in colour which might occur on the ceramic glass surface do not affect the functional structure
or permanence of the vitroceramic. The reason for the changes in colour is not the change in the
material; it may be because the burnt residues on the surface are not cleaned up or the pots used
have
worn the glass surface or because unsuitable cleaning materials were used .
The cleaning spatula should always be used prior to chemical cleaning substances. With this spatula,
you can clean up the tiniest of dirts on the vitroceramic surface . Dirts that are difficult to remove , such
as melted plastic, heavy oils, sweet substances, can be removed easily with the spatula. As the
spatula includes a razor, it is dangerous and must be kept out of reach of children
During cleaning with the spatula, pay attention not to scrape off the sillicon adhesives found on the sides
of the glass.
.