Candy PVU 647 X - Manual (Page 16)

1.........
2 - 3....Heating in Low Temperature
4-5-6...Cooking, Frying and Boiling
While using the electric burners, attention should be paid that the pots used have smooth
even bottoms. You can obtain maximum performance from your hob if you use pots with
suitable diameters and even bottoms. Using pots with small diameters on burners with large
diameters is not recommended. Because that will cause heat loss and lead to a waste of energy.
CORRECT
WRONG
pot bottom is round pot buttom is small pot buttom does not sit well
Burner
control knob
mperature is very high.
eating unit is run, you
hnical structure of the
ots should rub against
come damaged. It is
Re S istance of the vitroceramic glass to heat and extreme changes of te
A redness will be noticed on the heated surface with time. When any h
may hear a weak sound; this is normal and it has to do with the tec
system.
It does not pose any problems in terms of quality. In case sharp-edged p
or roughly placed on the vitroceramic glass, the surface may be
recommended that you pay attention to this.
14
ENG
4.2 USING THE COOKTOP BURNERS:
WRONG WRONG
The hob part of the product is controlled by energy regulators. Please see Figure 3.
( PVU 647 X-PVU 647 N )
Keeping warm
Figure 3
6
5
4 3
2
1
6
5
4 3
2
1
6
5
4 3
2
1
Dual or Extensible Zone Vitroceramic Burner
Dual or extensible zone vitroceramic burners
can heat in two different position. For operating
the big diameter of dual zone vitroceramic
burner turn the switch to ‘’ ‘’. Both big and
small diameter of the burner will operate. For
operating the extensible part of the extensible
zone vitroceramic burner, turn the switch to
‘’ ‘’. Both extensible and round parts will
operate.