Candy PVU 647 X - Manual (Page 11)

9
ENG
Insert the oven into cabinet partly by pushing it forward. Open the oven door and insert 4
screws into countersunk holes on the front frame. Locate the spacers behind the flange of
front frame and screw them till the surface of spacer touches the front frame. While doing
this, please pay attention that the chamfered edge of each spacer is faced to the rounded
edge of front frame. Push forward the product completely and finally screw it to wooden
part.
The dimensions and material of the cabinet in which the oven will be installed must be
correct and resistant to increases in temparature. In a correct installation, contact with
electrical or insulated parts must be pervented. Insulating parts need to be fitted in a way to
ensure that they cannot be removed by using any kind of tool. Installing the appliance in the
close vicinity of a refrigerator or a deep-freezer is not recommended. Otherwise, the
performance of the above-mentioned appliances will be negatively affected due to
emanating heat.
Warning regarding the installation of built-in oven without cooling fan
5mm 5mm
Prior inserting the oven, it is necessary to remove the
rear kitchen element panel in the area of the oven
opening.
Equally, the front part of the element must have an
opening of no less than 5 mm.
Fixing the oven:
( FUS 100-40 W
FUS 100-40 X )