Changhong MRF-410 - Manual (Page 26)

26
EN
Troubleshooting recommendations
• Read the following information on
how different errors are displayed.
• In case of multiple errors that re-
quire concurrently displaying codes
Е0 and Е1, the display will show
Е2.
№ Malfunction
Type
Displayer Showing
1 Malfunction on
the sensor of re-
frigeration room
Showing: «E0» in the
«temperature of refrigera-
tion room setting» zone
2 Malfunction on
the sensor of
freezer room
howing: «E0» in the «tem-
perature of freezer room
setting» zone
3 Malfunction on
the sensor of
evaporator in
refrigerator
Showing: «Е1» in the
«temperature of refrigera-
tion room setting» zone
4 Malfunction on
the sensor of
evaporator in
freezer
Showing: «Е1» in the
«temperature of freezer
room setting» zone
5 Malfunction on
the sensor of
environment
temperature
N/A
6 Malfunction on
the communica-
tion
Showing: «ЕС» in the
«temperature of freezer
room setting» zone
PRACTICAL TIPS
Switching off the refrigerator
• Remove the plug from the socket.
Remove the ice tray and products
from the refrigerator.
• Leave the door cracked open to en-
sure air circulation inside the refrig-
erator and dry both compartments.
• After switching off the refrigera-
tor, wait at least 10 minutes before
switching it on again.
• If you are going to switch off the re-
frigerator for a long time, you need
to disconnect it from the mains and
thoroughly clean it. Do not forget to
leave the door slightly ajar; store the
refrigerator in a well-ventilated area
to prevent unpleasant odours.