Plantronics MDA200 - Manual (Page 8)

8
Desk phone: connect and call
There are three set-up options for connecting the MDA200 to your desk phone. Select one of
the following and continue.
• Desk phone (standard)
• Desk phone + HL10™ lifter and power supply (sold separately)
• Desk phone + EHS cable (sold separately)
NOTE If you will be using Desk phone (standard) or Desk phone +HL10 lifter and power supply
continue below. If you will be using the Desk Phone + EHS cable , refer to EHS Getting Started
guide that came with your EHS cable or at plantronics.com/accessories for installation
instructions.
Desk phone (standard)
1 Connect one end of the telephone interface cable to the back of the switcher.
2 Disconnect the handset coil cord from the base of the desk phone and re-connect it to the
telephone interface cable junction box.
3 Connect the remaining end of the telephone interface cable into the open handset port on the
desk phone.
NOTE Your desk phone handset will continue to work; it’s just hooked up differently.
USE
NOTE If your phone has a built-in headset port, you should only use the headset port if you will not
be using the HL10 lifter. In this configuration, you must press both the headset button on your phone
and the call control button on the headset to answer or end calls.