Plantronics MDA200 - Manual (Page 10)

10
NOTE If you will be installing the HL10 lifter and power supply, continue below. If not, continue
with Computer: Connect and Call .
Desk Phone Plus HL10 lifter and Power Supply (sold separately)
1 Plug one end of the power supply into the power jack on the back of the MDA200 and the other
end into a working power outlet.
USE
2 Firmly press the handset lifter power cord into the handset lifter jack.
3 While wearing your headset, slide the handset lifter arm under the handset until the lifter base
touches the side of the phone.
4 Slide the lifter up to where it nearly touches the handset earpiece.
5 Press the call control button on your headset to activate the lifter.
6 If you hear a dial tone the lifter is set correctly and needs no adjustment.
7 Remove the protective strips from the 3 mounting tapes on the underside of the lifter.