Operating methods, Startup, System reset – JVC KV-PX701 User Manual
Page 14: Shutdown, Using the vehicle bracket
14
Operating Methods
Startup
1. For first time use, please turn
the system power switch at the
rear side On.
2. Press and hold the power button
for about two seconds to turn on the power.
Note: Before using for the first time, please switch the system power
on.
It takes one minute.
System Reset
It will only be required to rebootthe system under extremely few circumstances.
Reset your system if the following situations occur:
1. Heavy lag experienced when refreshing screens or operations, which result
in an inoperable system.
2. Cannot turn off the system with the power button.
3. No response after a selection is made on the screen.
If any of the above occurs, turn the system power switch at the rear side Off and
turn it back On to reboot the system.
Shutdown
1. While the power is on, press the
power button to turn the power off.
2. If the unit will not be used for a
long time, turn the system power switch at the rear side Off.
Using the Vehicle Bracket
The included vehicle bracket set can be
securely mounted on the front
windshield, or secured on top of the
glove compartment using the adhesive
plate. This device will effectively secure
the GPS unit in the vehicle. Follow the
procedures below to secure the bracket:
1.
Follow the arrows and slide the
unit into the in-vehicle bracket fitting holes to secure.
2.
Gently push down until the unit is tightly fixed with the bracket.
System
power
switch
Power button