Siemens TK76009 - Manual (Page 40)

36
de en
Rinse all parts with clear water and dry
them.
Reassemble all the parts and replace fully
in the appliance.
Note: All the parts of the milk frother 10 can
also be put in the dishwasher.
Cleaning the brewing unit 24
(refer also to the quick reference guide)
In addition to the automatic cleaning
programme, the machine offers the option
of removing the brewing unit 24 for
cleaning.
Switch to the “energy saving mode” with
the
a
button 2.
Switch the appliance off completely at the
power on/off switch 1 O / I; no buttons
are lit.
Slide the door opener 23 to the right and
open the door 22 to the brewing unit 24.
Slide the red lock 24b on the brewing unit
24
completely to the left.
Press the red button 24a, grasp the
brewing unit 24 by the recessed grips
(Fig. E) and remove carefully.
Rinse the brewing unit 24 under running
water.
Important: Clean without detergent and do
not place in the dishwasher.
Wipe out the inside of the appliance with
a damp cloth.
Allow the brewing unit 24 and the inside
of the appliance to dry.
Reinsert the brewing unit 24 fully into the
appliance.
Slide the red lock 24b fully to the right
and close the door 22.
●
●
●
●
●
●
●
●
●
●
●
●
Storing accessories
The espresso machine has special com-
partments for storing the accessories and
quick reference guide inside the appliance.
To store the measuring spoon 14, milk
pipe 10d and tube 10c, remove the water
tank 11 and insert the parts in the shaped
recesses 13.
The quick reference guide has its own
compartment by the brewing unit 24.
Open the door 22 to the brewing unit.
Grasp the red cover 26 to the storage
compartment 25 by the tab and remove.
Stow away the quick reference guide,
replace the cover 26 and close the door
to the brewing unit 22
Tips on energy saving
The fully automatic espresso machine
switches to “energy saving mode”
automatically after one hour (factory
setting). The appliance uses very little
power in “energy saving mode”. The
default time of one hour can be altered:
(see Menu settings, “
A
UTO OFF AFTER ”) .
If the appliance is not being used, switch
it off at the power on/off switch 1 O / I on
the front.
If possible, do not interrupt coffee or milk
froth dispensing. Cutting the coffee or
milk froth dispensing process short
results in higher energy consumption and
in more residual water collecting in the
drip tray.
Descale the appliance regularly to avoid a
build-up of limescale. Limescale residue
results in higher energy consumption.
●
●
●
●
–
–
–
–
SE_TK76_Teil_1_080917.indd 36 18.09.2008 08:40:49