HONDA 2012 CR-Z - Manual (Page 309)

307
uu Fuses u Inspecting and Changing Fuses
Han
d
lin
g the U
n
expected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK ( 0 . Turn
headlights and all accessories off.
2. Check the fuses in the engine
compartment.
u If the fuse is blown, have it replaced by a
dealer.
3. Inspect the small fuses in the vehicle
interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 304 to P. 305.
There is a fuse puller on the fuse box.
Fuse
Blown
Fuse
Fuse Puller
12 CR-Z-31SZT610.book 307 ページ ２０１１年８月２９日 月曜日 午後８時８分