HONDA 2010 Pilot - Manual (Page 232)

You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
On the AM band, AM noise
reduction turns on automatically.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button, or AM/FM button. On
the FM band, ST will be displayed if
the station is broadcasting in stereo.
Stereo reproduction in AM is not
available.
On the FM band, you can also use
the features provided by the radio
data system (RDS). For more
information on the RDS, see page
.
The skip function searches
up and down from the current
frequency to find a station with a
strong signal. To activate it, press
and hold the
or side of the
SKIP bar until you hear a beep, then
release it.
Use the selector knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
230
To Select a Station To Play the Radio SKIP
TUNE
Playing the FM/AM Radio (EX and EX-L models)
228
2010 Pilot