FIAT Panda Classic - Manual (Page 111)

Assembly diagram fig. 4
The tow hook structure must be fastened
in the points shown by the symbol
Ø us-
ing a total of 4 M8 screws and 2 M12
screws.
The internal counterplates 1 are to be at
least 6 mm thick. The hook should be fas-
tened to the body avoiding any type of
drilling and trimming of the rear bumpers
that remains visible when the hook is re-
moved.
IMPORTANT It is compulsory to fasten a
label (plainly visible) of suitable size and
material with the following wording:
MAX LOAD ON BALL 60 kg
After fitting, screw holes shall be sealed to
prevent an exhaust gas inlet.
110
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
SAFETY DEVICES
CORRECT USE OF THE CAR
fig. 4 F0G0226m
Existing hole
Existing hole
Existing hole
Existing hole
Standard tow ball
Existing screw
Existing screw
101-112 Panda New GB 21-06-2007 13:50 Pagina 110