FIAT 500 - Manual (Page 54)

53
SAFETY DEVICES
CORRECT USE OF THE
CAR
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
YOUR CAR
HEADLIGHTS
BEAM DIRECTION
The correct orientation of the headlights
is important for drivers comfort and safe-
ty. Besides, it is a specific rule of the high-
way code.
The headlights must be correctly directed
to ensure the best visibility conditions for
all drivers.
Contact Fiat Dealership to have the head-
lights properly adjusted.
Check beam aiming every time the load or
its distribution changes.
IMPORTANT When turning on (Xenon)
gas discharge headlight lamps (for ver-
sions/markets, where provided), it is nor-
mal that there should be a vertical move-
ment of reflectors, and consequently the
same will also happen to the light beam,
for the time required to achieve the cor-
rect headlight trim stabilisation, equal to
approx. 2 seconds.
ROOF RACK/SKI RACK
FASTENERS
The fasteners are located in the area in-
dicated in fig. 59.
To use the front fasteners, remove the cap
A, accessible with the door open. To lo-
cate rear fasteners B, refer to fig. 59a.
Lineaccessori provides a specific rack/ski
rack on tailgate.
IMPORTANT Follow the instructions
contained in the assembly kit to the letter.
Assembly must be performed by qualified
personnel.
fig. 59 F0S0136m
After travelling for a few
kilometres, check again that
fastening screws are properly tight-
ened.
WARNING
Never exceed the maximum
allowed load (see “Technical
Specifications”).
Evenly distribute the load and
take into account, when dri-
ving, the increased respon-
siveness of the car to side
wind.
Comply with applicable laws
concerning maximum over-
all dimensions.
WARNING
fig. 59a
30 mm
130 mm
B
F0S0152m