FIAT 500 User Manual
Page 145
144
W
ARNING
LIGHTS AND MESSAGES
TECHNICAL
SPECIFICA
TIONS
INDEX
YOUR CAR
SAFETY DEVICES
CORRECT USE OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
BRAKE FLUID fig. 1-2-3
Release cap E
: check that the liquid con-
tained in the tank is at the maximum level.
Fluid level in the reservoir must not ex-
ceed the MAX mark.
Use the brake fluid shown in the “Fluids
and lubricants” table (see “Technical Spec-
ifications”).
NOTE Carefully clean the cap of reservoir
E and the surrounding surface.
When opening the cap, make sure that no
dirt gets into the reservoir.
For topping up always use a funnel with
built-in filter (mesh smaller than or equal
to 0.12 mm).
IMPORTANT Brake fluid is hygroscopic
(i.e. it absorbs moisture). For this reason,
if the car is mainly used in areas with a high
degree of atmospheric humidity, the fluid
should be replaced at more frequent in-
tervals than specified in the “Service
schedule”.
Prevent brake fluid which is
highly corrosive from coming
into contact with painted
parts. Should that occur, im-
mediately wash with water.
The brake fluid is poisonous
and highly corrosive. In the
case of accidental contact, wash the
parts with water and mild soap and
rinse with plenty of water. In case of
swallowing immediately call a doctor.
WARNING
The symbol
π
, on the con-
tainer indicates a synthetic
brake fluid, which is different from a
mineral fluid. Use of a mineral type
fluid will damage the special rubber
seals of the braking system beyond re-
pair.
WARNING