Edimax Technology CV-7428nS - Manual (Page 10)

10
Hardware Installation for guidance on using the wireless bridge with your
network device.
II-2. iQ Setup
1. Connect one end of an Ethernet cable (included in the package contents) to
the Ethernet port on your computer. Connect the other end to an LAN port
on the wireless bridge.
2. Plug the power adapter into the device’s 5V power port, and plug the
adapter into a wall socket. The PWR LED should light up.
Note: Before you use the wireless bridge, please make
sure your computer is set to use a dynamic IP address.
This is a simple procedure, and step by step instructions
for how to do this, can be found in
IV-1-1. How to
configure your computer to use a dynamic IP address.
3. Open a web browser, and you will be prompted for a username and
password.
Note: If you are not prompted for a username and
password, please enter “http://edimax.go” into the
URL bar.
4. Please enter the default username “admin” and the default password
“1234”.